I2C-HAT Enclosure

Stackable DIN Rail Enclosure for Raspberry Pi and [I2C-HATs](https://raspihats.com/) automation boards.
You can install Raspberry Pi and any of the [I2C-HATs](https://raspihats.com/) in this enclosure, stack them and even mount the stack on a DIN Rail.
You'll need 4pcs M2.5x5 bolts to install the boards in this enclosure.

**What to print?**
For a complete enclosure you should print:
1. [I2C-HAT Enclosure](https://www.thingiverse.com/download:4908909)
2. Side Panels for your board type(see below)
3. [Lid](https://www.thingiverse.com/download:4908911), one Lid per stack, the Lid is not required for all enclosures in the stack, only for the last one. In a stack the bottom of an I2C-HAT Enclosure acts as a Lid for the I2C-HAT Enclosure located underneath.
4. [DIN Clip](https://www.thingiverse.com/download:4908912), only required if your going to mount the stack on a DIN Rail, not required for every I2C-HAT Enclosure in the mounted stack.

**The Side Panels**
The I2C-HA