Thingiverse
Iambic Paddles (Base Mountable Version)
por ReallyBigTeeth
355
Descargas
239
Likes
19
Makes
If you like what you see here, consider leaving a tip.
Remixed from an excellent design by Thingiverse user and certified amateur radio operator Loren Butler (V01PWF), the intent of this project was to make a set of 3D printable iambic paddles that were as portable as possible, while still comfortable enough to use at a desk. I could have made the overall width narrower if I removed the key end stops from the base and built them in to the top cover, but I wanted to have the option of removing the cover and mounting the key to a heavy base plate. The narrow version of this key can be found here, and a mini version can be found here.
Hardware Used:
3x 6-32 x 1 inch phillips flat pan head screws for paddle pivots and ground contact
2x 6-32 phillips flat pan head screws trimmed to 11.5mm thread length for paddle contacts
2x 6-32 nuts/springs and washers for paddle contact screws
4x 6-32 1/4 inch phillips flat pan head screws for attaching the cover
1x 1/8 inch stereo jack or hot glue
Remixed from an excellent design by Thingiverse user and certified amateur radio operator Loren Butler (V01PWF), the intent of this project was to make a set of 3D printable iambic paddles that were as portable as possible, while still comfortable enough to use at a desk. I could have made the overall width narrower if I removed the key end stops from the base and built them in to the top cover, but I wanted to have the option of removing the cover and mounting the key to a heavy base plate. The narrow version of this key can be found here, and a mini version can be found here.
Hardware Used:
3x 6-32 x 1 inch phillips flat pan head screws for paddle pivots and ground contact
2x 6-32 phillips flat pan head screws trimmed to 11.5mm thread length for paddle contacts
2x 6-32 nuts/springs and washers for paddle contact screws
4x 6-32 1/4 inch phillips flat pan head screws for attaching the cover
1x 1/8 inch stereo jack or hot glue
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!