icinga.com logo, 3Dfied, segmented
von kartellchef
2
Downloads
2
Likes
1
Makes
[The 3Dfied icinga.com logo](https://www.thingiverse.com/thing:3866926) divided by its spheres and cylinders for 3D printing it bigger and slots for the cylinders in the spheres not to require any glue.
Every part must be printed exactly once.
**Do not print the cylinders as-is!** The slots for them have been made by boolean or operations, so they're exact in theory. But **in the field** they seem to be "too exact", so the cylinders are **a bit too big** to be plugged into their slots. Solution:
1. Place all models on the slicer's build plate.
2. Scale all of them at once as you need.
3. Scale the cylinders' shortest side a little bit down, e.g. by a small multiple of the line width. [This one](https://www.thingiverse.com/make:729797) (scale: 490%) required a tolerance of 0.5mm.
Every part must be printed exactly once.
**Do not print the cylinders as-is!** The slots for them have been made by boolean or operations, so they're exact in theory. But **in the field** they seem to be "too exact", so the cylinders are **a bit too big** to be plugged into their slots. Solution:
1. Place all models on the slicer's build plate.
2. Scale all of them at once as you need.
3. Scale the cylinders' shortest side a little bit down, e.g. by a small multiple of the line width. [This one](https://www.thingiverse.com/make:729797) (scale: 490%) required a tolerance of 0.5mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
