ID Badge Holder

Purpose
I needed a new badge holder for work, so I turned out a reproduction of a busted holder from a co-worker. The dimensions should allow for two cards (snugly) on one side, and one card on the other..

I recommend the "horizontal" print orientation as noted in the "Print Settings" section.

Changelog

v1.0: Initial Release
v1.2: Fixed some dimensional inaccuracies in the spacing of the card slot.
v1.3: Final fit of 1.2 was successful, but could be too snug if using materials with any contraction in the print. Added another .25 mm tolerance for the internal length.
v1.4: Structural support added to the main body. I was a bit too aggressive in removing supports from a print and noticed a seam which could use some work (because, you see, I broke it).
v1.5: Added back the missing tension strips on the back face of the model.
v1.6: Fixed spacing on one set of the tabs.




Once I get a basic comfort level with Fusion 360, I'll add a model in which I will fillet all edg