MakerWorld
Organizers
Go to Model
ID Card case
46
Downloads
22
Likes
26
Makes
A case for the ID card. The part to take out the card, must be put into the case after printing.When inserting the card, you should place the card under the small component. Once that's done, all you have to do at the end is press it a little and the card is solid in place.For an even printing result, I set the Max volumetric speed for the Translucent PETG from 6mm/s to 4 mm/s.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
