ID Lanyard - DA OFT Switchblade

Made this as a gag since our university does not specifically forbids concealed knifes, but to be on the safe side I made the knife into a dull rectangular bar that says: "not a knife :)" in comic sans font.

I posted this on r/functionalprint and someone asked for me to upload this here. Heed those who will try to make this: it's really poorly designed, tedious to assemble and barely works half of the time. Refer to the parts callouts picture for how the trigger mechanism is assembled.

Adding the rubber band in particular is a pain.

I going to add detailed instructions later but for now this is the cliftnotes version:

-Print one over everything except the rubberbandring.stl which requires 2
-Upper and Lower locks slot into the Bottomcase
-Superglue each of the rubberbandring into the blade puller/pusher cut a rubber band into a string, thread it through the rings and knot them into a loop, cut near to the knot as much as possible since the bigger the slack, the more cha