iDROID Heltec32 Meshtastic Prototype Case 1a

My only wish was to take these two items, and make them cooperate, to make an important prop in gaming history function to some degree.

Heltec users, I did place holes in idroid frame for antenna, top button, and port on bottom. My hope was this will work with some wire extensions, and no more than that to keep it simple as possible. B8B8 provided a parts list for their build, so I am also putting them here :

Parts:
4x M3x25 socket head cap screw
4x M3 Nut
1x 1/4"-20 Nut
1x Heltec Lora32 V2 development board
1x small lipo battery
1x GX12 Aircraft connector
1x 90 degree micro USB Cable
1x switch

---> Some parts like his original case should be omitted for this remix, as it will be protected with Bruno_Sznajder idroid case.

B8B8 also stated some instructions as well for the Heltec32 :
Wiring:
Cut the 90 degree USB cable roughly 2 inches from the tip. Next Solder each of the 4 colored wires to GX12 connector. Make sure you MATCH the wire colors to the same pin number