Thingiverse
iDSonix Powered Hub Holder
von badiozam
2
Downloads
2
Likes
0
Makes
A sleeve for this powered hub station:
https://www.amazon.com/gp/product/B08PF3VTF9
The thing rolls over too easily because the base isn't heavy enough. Plus I wanted something that I could stand upright or on its side.
Uses two M3x40mm bolts with corresponding nuts at the bottom (optional, you can probably just thread into the PLA) to secure the hub once inside the sleeve.
https://www.amazon.com/gp/product/B08PF3VTF9
The thing rolls over too easily because the base isn't heavy enough. Plus I wanted something that I could stand upright or on its side.
Uses two M3x40mm bolts with corresponding nuts at the bottom (optional, you can probably just thread into the PLA) to secure the hub once inside the sleeve.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
