IERC empire electronics tray

i designed this for my IERC empire Xtreme chassis to hold my ESC and RX. it should also fit the regular empire chassis. these chassis are so confined its hard to figure out where to place everything. after i got this installed i realized i needed 2mm spacers between the mounts and the tray to clear the center driver shaft. i didnt really feel like modding it for 2MM when i had spacers on hand. i didnt taper the holes so i just used a drill bit and tapered it by hand. on my regular empire chassis i used it to hold the battery with velcro.

THE 9.5MM and 11MM O2O means outside to outside of the hole's, in tinkercad it was easier to measure that way then hold center's the 9.5MM works for the front and 11MM for the rear shock mount's