iFactory One fixed Displayholder

This is a fixed Version of the iFactory One Displayholder.
My original breaks after the first touch on the free hanging edge.
So I redesign it and makes it more stable.

So use the longholes with the original screws and t-nuts and slightly push them into the aluminium extrusion. Then push slightly the holder with the new bar into the extrusion until the end and screw it up.

So this problem is very simple fixed.

If you are printing it on cartesian printer you needs supports.
The best is linear support with touching everywhere.
But put support-blockers onto the screwholes inner the box.

With iFactory One themself you have to practise because my doesn't work for now.
Perhaps you did not need any supports.