Thingiverse
Music
Model downloaden
Ifi Zen Rack
19
Downloads
17
Likes
1
Makes
This is a rack to stack ifi zen components. It creates a solid combination of two ifi Zen components, e.g. Zen Dac and Zen Can
To combine the front and the back plate use 2.5mm cable straps or 3mm threaded rods and (cap) nuts.
Depending on your Zen you should use PETG or ABS instead of PLA, because e.g. the casing of Zen Can gets warm.
To combine the front and the back plate use 2.5mm cable straps or 3mm threaded rods and (cap) nuts.
Depending on your Zen you should use PETG or ABS instead of PLA, because e.g. the casing of Zen Can gets warm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
