Thingiverse
iFlight iX3 - VTX Pigtail Mount
14
Downloads
6
Likes
0
Makes
This piece provides a 20 degree back-angled mounting hole to screw on an SMA pigtail pushed up from below. As a bonus, it also provides a rear-facing flat-edge where I attached my LED strip and buzzer.
Designed this part to press-fit over the vertical support struts on a iFlight iX2 Lite V3
This frame:
https://smile.amazon.com/gp/product/B07H96PQWQ
Although the frame looks like it has a mounting hole on the top bracket, that is too small for SMA.
May require a soft mallet and block of wood to press in place, depending on your print settings and tolerances.
[Edit 7/6/2019]: I added an .stl for a new version with channels for antennas, set apart at 33 degrees. Previously I was just poking them through the frame top and didn't have a great spot for them. Now they have shielded channels to protect from motor strikes and a little stack you can use to shrinktube the antennas in place. Won't work with all antennas so I'm only including it as an additional model.
Designed this part to press-fit over the vertical support struts on a iFlight iX2 Lite V3
This frame:
https://smile.amazon.com/gp/product/B07H96PQWQ
Although the frame looks like it has a mounting hole on the top bracket, that is too small for SMA.
May require a soft mallet and block of wood to press in place, depending on your print settings and tolerances.
[Edit 7/6/2019]: I added an .stl for a new version with channels for antennas, set apart at 33 degrees. Previously I was just poking them through the frame top and didn't have a great spot for them. Now they have shielded channels to protect from motor strikes and a little stack you can use to shrinktube the antennas in place. Won't work with all antennas so I'm only including it as an additional model.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!