Thingiverse
Replacement Parts
Zum Modell
igloo cooler drain plug replacement
1
Downloads
14
Likes
0
Makes
The dang thing broke off so I had to make a new one, but it was fun, so it's ok!
I printed in TPU for the final and added ribs for strength.
This was done on a Flashforge Adventure 5M.
50% or greater fill (used triangular)
lowered the speed to the recommended 50mm/s for adhesion
I printed in TPU for the final and added ribs for strength.
This was done on a Flashforge Adventure 5M.
50% or greater fill (used triangular)
lowered the speed to the recommended 50mm/s for adhesion
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
