Ikea Adils 40mm support bracket

Not technically a remix since I completely redesigned this using Fusion360. Although to be fair, it was fully inspired by https://www.thingiverse.com/thing:1656880, so I'll give remix credit.

I wanted something I could use to support the four legs of a table, not add a shelf, so I added a 90deg support tab. Print four (one for each leg), screw clamp them so they don't rotate (should be plenty, doesn't have to be crazy tight), then wood screws into the cross supports.

- I'm using a 1x2 for the cross supports
- The clamp holes are 3.5mm, I use an M3 x 16mm with washers, lock washer, & nut
- The base mount holes are 5mm and sized for a #8 wood screw, 3/4"