Thingiverse
Ikea ADILS Table Leg Extender
door Bo_Ris
34
Downloads
23
Likes
1
Makes
If you need to extend ADILS, or similar table leg sold by Ikea, here is one of the ways to do it.
The leg comes with a plastic piece at the bottom attached to M8 bolt. Find a longer M8 bolt with hex head and print 2 things published here. I used M8 x 70mm bolt, similar to the one holding spool mounts of VERTEX K8400 printer and gained over an inch of height.
The leg comes with a plastic piece at the bottom attached to M8 bolt. Find a longer M8 bolt with hex head and print 2 things published here. I used M8 x 70mm bolt, similar to the one holding spool mounts of VERTEX K8400 printer and gained over an inch of height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
