IKEA Drawer Bottom Support / Reinforcement Bracket

This is a simple 3D printable support bracket designed to reinforce the thin fiberboard bottom panel on an IKEA-style drawer.

Over time, drawer bottoms can start to sag, loosen, or pop out of the frame, especially when the drawer is loaded with heavier items. This bracket helps hold the bottom panel in place by bridging the drawer frame and the center board, adding extra support around the perimeter.

The model is low-profile and mounts with two small screws. It can be used on the bottom, sides, or top edge of the drawer depending on where extra support is needed.

Features
Designed for IKEA-style drawer bottoms with thin MDF/fiberboard panels
Helps prevent drawer bottom sagging or separation
Simple two-screw installation
Low-profile design
Can be printed quickly with minimal material
Useful for repairing or reinforcing existing drawers
The screw holes are designed for M2 × 10 mm self-tapping screws.
Dimensions

Approximate model size:

Length: 40 mm
Width: 9 mm
Height: 9 mm
Print Set