Thingiverse
IKEA GREJIG Spacer
by mastein93
1
Downloads
4
Likes
0
Makes
Just a small spacer to get the level of the rack a little bit higher.
In the photo, I printed it in PLA with high velocity on an Ender 3 V2 and a 0.28 layer height. Doesn`t look that good but still works.
Feel free to make some comments regarding the tolerances, to make it snap a littel bit smoother. I just didn`t want to print it again. :-)
In the photo, I printed it in PLA with high velocity on an Ender 3 V2 and a 0.28 layer height. Doesn`t look that good but still works.
Feel free to make some comments regarding the tolerances, to make it snap a littel bit smoother. I just didn`t want to print it again. :-)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!