Ikea Hack Lack Enclosure v1.0

THIS IS A WORK IN PROGRESS TO ADD MORE PIECES

Ikea Lack enclosure for 3d printers, the "foot support " raise the table about 6cm.
The corner pieces have holes to places neodimiun magnet to hold a polycarbonate windows.
All pieces must be attached with screw to the table.

Like i said is a work in progress, in the future i `ll upload more functional pieces.

Enjoy

Update1:
Added a few more pieces¡
-Cable trought: to properly run cables from the bottom to the top.
This pieces consist in three parts.
-PowerSupply support for a TFX PSU . Two parts
-Control panel for on-off switchs and two usb.
For the usb i use this: https://es.aliexpress.com/item/USB-A-Female-Breakout-Board-5V-Power-2-54mm-Header/32492164824.html?spm=a2g0s.9042311.0.0.tD0Yan

-Cable clamp with ties for cable management