Slicer Discord
Ikea Ivar Cable Holder – 3D-Druckmodell von MakerWorld MakerWorld
Organizers

Ikea Ivar Cable Holder

von 3Driv · Organizers
24 Downloads
14 Likes
14 Makes
Zum Modell
Did not find a cable management that lived up to my expectations for the Ikea Ivar shelf. This version works for most AC/larger cables at home. I have made a smaller model, used for smaller cables, but have not found is as useful as the large version. This model prints flat and no support needed. Brim recommended depending on your adhesion.If you need more grip, feel free to alter the model. I've found that much larger peg diameter makes the installation more or less permanent in your shelf. Write in the comments if I should share the model for smaller cables!Enjoy!
Kategorie
Organizers
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen