Ikea Ivar Doorstop

Adding some Ikea Ivar shelves to a room recently, found the door bumping into it. Rather than have the hard plastic of the handle and wood frame smack together, I sketched up a door stop. I then went mad and sketched up several others to cover all situations.

There are two styles: chunky and slim. Both styles have a 'face' version, which acts as a stop against anything bumping up against the face of the shelves, and an 'end' version that covers the ends of the shelves.

Chunky uses about twice the filament as the slim, but I suspect would be more robust. Plus, I think they look better. The downside is that there are holes that print vertically, so may end up a bit messy. The vertical tubes on the hole side are to help support those loose ends during printing, another issue. It all works, just not as pristine as you may like.

The slim versions were made to try and combat the above issues. Prints flat and uses less filament. May be weaker, however.

#### Printing


All types are to be