Thingiverse
IKEA Lack Leg Extender
von Centurytt
7
Downloads
11
Likes
0
Makes
Hi,
this Leg extender for IKEA LACK Table, is to be used if you would like to built an enclousure for your Printer. With this extender you will be able to rise the hight for 110mm. To stack it into the leg, you need to drill a hole with diameter of 14mm.
You are also be able to use wood boards for the sides with about 1-1,5 cm thickness, or just Plexiglass like I do.
Enjoy
this Leg extender for IKEA LACK Table, is to be used if you would like to built an enclousure for your Printer. With this extender you will be able to rise the hight for 110mm. To stack it into the leg, you need to drill a hole with diameter of 14mm.
You are also be able to use wood boards for the sides with about 1-1,5 cm thickness, or just Plexiglass like I do.
Enjoy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
