Thingiverse
Ikea Lack Stacking Stilts
por niik
13
Descargas
7
Likes
0
Makes
i created these to extend the legs of my Ikea Lack table so my 3D printer would fit under the table when it was stacked on another Lack table.
The print adds about 100mm of height.
The bottom has 2 tabs that hold the top of another lack table to help with stability but they would get in the way if used on a flat surface.
The print adds about 100mm of height.
The bottom has 2 tabs that hold the top of another lack table to help with stability but they would get in the way if used on a flat surface.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
