Ikea LACK Table Extension Stacker

The standard height of an Ikea LACK table is 400 mm from the ground to the bottom of the table. This is a very snug fit for most Prusa style printers. If you add anything like feet or dampeners to the printer, then it just doesn't fit at all.

So I designed this extension stacker to raise the table by 80 mm. Not only does it give you more clearance, but it brings the printer closer to eye level if you place it on the stacked table.

The table leg sits 20 mm into the stacker and are a pretty tight fit by my printer's tolerances, you may need to use a rubber mallet to push it all the way in.

I printed mine at 0.32 mm layer heights and 30% infill with the orientation shown in the picture and it seemed to be strong enough.