Thingiverse
IKEA Lack Table - Filament guide
von lukewarmbicycle
6
Downloads
0
Likes
0
Makes
Small filament guide / gromet to suit the IKEA Lack table.
Printed using PLA
Dimension:
Small guide
12mm wide (10mm insert)
52mm long (50mm insert)
Large guide
24mm wide (20mm insert)
52mm long (50mm insert)
Installation method:
Use a 10mm drill bit for the small guide or a 20mm drill bit for the larger guide where you wish to install it. No other prep required, it will slide straight in.
Printed using PLA
Dimension:
Small guide
12mm wide (10mm insert)
52mm long (50mm insert)
Large guide
24mm wide (20mm insert)
52mm long (50mm insert)
Installation method:
Use a 10mm drill bit for the small guide or a 20mm drill bit for the larger guide where you wish to install it. No other prep required, it will slide straight in.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
