IKEA Lack Table Leg extender with brackets

Remix from https://www.thingiverse.com/thing:3025215

This is to replace the need to buy the small table in the remixed version, which also means no need to hollow those legs. Combined the bracket and the extender along with the actual extra leg. Modified the bracket and the extender since it's merged to the new leg.
Currently, the leg is at 25cm which fits my CR-10S perfectly for a total height of 65cm.

Should you need a different length, you can just increase the height or message me and i can produce different lengths if needed

Highly recommending printing with 100% infill, you won't save much but not doing so. Might as well get a solid build.

I'd go with 0.32 resolution