Ikea Linnmon Table Stablizer and Spacers

This was my solution to the classic Ikea Linnmon table wobble. The Linnmon is the table I use to 3d print on so I needed a solution for fear of bad print quality. I added table spacers to the back to save my cords from wear and tear and to keep the table from marking up the wall. The bracket slips onto the front of the table. It is held in place by using a lashing strap which is fed through the front bracket and then to a ceiling hook attached to the wall (in a stud preferably). You want this strap taught but not so much that you put dents in your wall. I have widened the back spacers to help with pressure points on the wall surface, so they are a bit wider than what is shown in the photos. The front bracket is spaced for a 27mm (or 1 inch) Strap width Materials you will need (links for ideas) 1 lashing strap (1 inch width) - https://a.co/d/aAEaLJN (or similar)1 ceiling hook - https://a.co/d/5sgR8Hb (or similar)2-4 Screws (2 inch) - https://a.co/d/gcm8S4P (or similar)