Thingiverse
IKEA Markus arm rest
von Hichi
39
Downloads
44
Likes
1
Makes
The original arm rest of my new office chair "Markus" was just too tall, so I was unable to slide it under my table.
I redesigned the whole arm rest in Autodesk Fusion 360.
Unfortunately you will need a plus sized printer to replicate this.
I redesigned the whole arm rest in Autodesk Fusion 360.
Unfortunately you will need a plus sized printer to replicate this.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!