Ikea Markus Armrest Lowerer Bracket

I printed the original and had some issues with them breaking.. immediately. Re-designed the bracket using the original to measure from.

For optimal strength print at 31 degrees using supports (check the image) and use solid infill going hole-to-hole with some zero degree plies (also in the picture). If you're using something better than the matte PLA I'm using maybe this is completely unnecessary. So far so good and nothing has broken. I designed these small accessories to lower them to a proper height.

You just need 4 bolts (1 for each arm chair screw hole) with 8mm diameter and 5 or 6 cm in length.