Ikea metod foot

I designed these low-profile feet to get my IKEA Metod cabinets as close to the floor as possible without the frame actually touching the ground. This protects the particle board from moisture (mopping, spills) while keeping a minimal look.Key details:Friction Fit: They are designed to press-fit tightly into the standard 10mm holes on the bottom of the Metod frame. No screws needed.Door Clearance: The profile is low but accounts for the door swing—you can open bottom drawers and doors fully without them scraping the floor.Stable: Flat bottom design provides plenty of surface area for stability.Print RecommendationsMaterial: PLA+ or PETG (PETG is best if these will be under heavy load long-term).Walls: 3 or 4 perimeters for strength (the pegs need to be strong).Infill: 20% or higher.Supports: None needed.InstallationJust flip the cabinet (or reach underneath) and push them into the pre-drilled holes. If the fit is too tight for your printer's calibration, you can scrape the pegs sli