Slicer Discord
Ikea Micke Side Phone Mount – 3D printable model from MakerWorld MakerWorld
Other House Models

Ikea Micke Side Phone Mount

12 Downloads
8 Likes
6 Makes
Go to Model
I use Ikea Micke drawers as a bedside table. The surface of the table is higher than the mattress so this keeps the phone where it can be used while laying down, and visible as a clock or video player, instead of in a standard holder that usually tip the phone upwards. With cats, it's nearly impossible to keep anything on the surface of the table consistently so this is designed to hold the phone along the side of the table. It fits on the side of any Micke drawer feature for other uses. The open tray design will fit most tablets, phones, and other thin devices up to 2cm thick.* The thin arm on the side prevents the device from falling forward without obscuring the screen. It doesn't need any hardware, it grips the side and doesn't interfere with the drawer function. I use a small amount of double sided tape on the front lip to discourage cat-shenanigans but it's only because it was designed to be taken off easily for moving around. This file is default attaches to the
Category
Other House Models
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Why?
no supports
Support-free Single piece Hardware needed
Supports 0/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

4 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection