Thingiverse
Ikea MICKE table cable cap
von Omnicolor67
12
Downloads
21
Likes
1
Makes
Altered cap from BenderV2.
I used version with hole, but - no! The table wood under the hole is visible.
So here you have the Cap fill stl. That one fits to the BenderV2's original design, if you have already printed that up, but is not perfect.
Fits cca 77mm hole in IKEA desks.
Instead, I created a version that already is full circle and the hole is only inside - stl called 1 opening. Plus some different fillets and chanfers. You will need a lower layer height for this one.
Finally, one of my cables for headphones went really nasty blocking my keyboard, so I created another, smaller hole just for this one (USB size approx. 1x2cm fits there without problems) - stl 2 openings.
Before printing, please check whether your cable endings fit the holes.
I used version with hole, but - no! The table wood under the hole is visible.
So here you have the Cap fill stl. That one fits to the BenderV2's original design, if you have already printed that up, but is not perfect.
Fits cca 77mm hole in IKEA desks.
Instead, I created a version that already is full circle and the hole is only inside - stl called 1 opening. Plus some different fillets and chanfers. You will need a lower layer height for this one.
Finally, one of my cables for headphones went really nasty blocking my keyboard, so I created another, smaller hole just for this one (USB size approx. 1x2cm fits there without problems) - stl 2 openings.
Before printing, please check whether your cable endings fit the holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
