Thingiverse
Ikea omlopp led bracket
von edinprint3d
15
Downloads
5
Likes
0
Makes
Just a quick little bracket I knocked up for holding an IKEA kitchen led on the top of my ender3. As these led's are 24v I could quickly wire it in to the psu, bracket fit's good left it a little lose to give a little give if peoples printer are not dialed in.
Fusion 360 included as well
Fusion 360 included as well
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
