Ikea parasol baggon pivot

After windy day, sunshade fell on the floor and the pivot broke. So I did a replacement.

To remove the original part, you have to unscrew the axle, and drill the 4 rivets.
I used 4.8mm rivet for replacement.

I printed the part in PETG with 100% infill to make it the strongest possible and water resistant.
You should printed as shown on the picture, on the side, for maximal structural strength. There will be support but they are not visible faces after installation.
If you print it verticaly, the layers might break appart.

If you broke the other part, there is a guy (wroblisko) who modelled it: https://www.thingiverse.com/thing:4380873