Ikea Rodd Moonlamp

**Please read the instructions**
(As a general rule in life, always read the instructions, even if you don't follow them)
***

The job accomplished by moononournation is absolutely amazing (check out his instructable to understand how complex it was to create this moon) but it's your responsibility to build something cool with it and that's where I come in :-)

Hereby I present you my mod to make an Ikea Rodd lamp shade from his moon.


***


**Instructions:**
*Print parameters:*
100 microns layer height, 100% (yes, 100%) infill, non-tree supports touching the build plate. Of course, it's very much advised to print it in one solid piece for the best result.
Depending on your printing speed and your nozzle, this may need up to a week to finish. I personally did it in **two days** with a 0.8 mm nozzle. I also used about 250g of PETG, so that's significant.


You can either print my version or build your own (mostly because you want a smaller or bigger lamp shade but al