Thingiverse
Ikea shelf filament guide
von Raafz0r
3
Downloads
0
Likes
0
Makes
A way to feed filament through a shelf without it snagging or abrading. Designed to fit an 18mm Ikea shelf, where the part is printed twice and used for top and bottom.
Route an 8mm slot over a 100mm length and insert the parts. Should be a snug fit that does not require glue.
Route an 8mm slot over a 100mm length and insert the parts. Should be a snug fit that does not require glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
