Thingiverse
IKEA Skadis double scissors holder
von AJP22
7
Downloads
9
Likes
1
Makes
Remixed in OpenSCAD. Original by 3DBall.
Pro tip: if one of your pairs of scissors is larger than the other, you can heat up the part on your print bed or with a hair dryer to bend the middle wall to make them fit better (see 3rd picture)
Warning: don't run with scissors
Pro tip: if one of your pairs of scissors is larger than the other, you can heat up the part on your print bed or with a hair dryer to bend the middle wall to make them fit better (see 3rd picture)
Warning: don't run with scissors
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
