MakerWorld
Organizers
Model downloaden
Ikea Skadis Wire Spool Holder
49
Downloads
13
Likes
23
Makes
Looking around at the other wire spool holders out there, I wasn't terribly satisfied. All seemed to use a bit more filament, had finicky printing (supports, post processing), or just wouldn't hold the number of spools I had. So I made this one. It holds 6 spools, has feed-holes in the bottom front, and supports holding 6 spools up to 60mm in diameter. Since this uses the Skadis T-Nut system, you will need the following hardware:2xM2.5x10 Bolts2xM2.5 NutsI've added these to the BOM below, so if you don't have any on hand you can purchase some from Bambu Labs
Paradox publiceert ook op
32 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
