Thingiverse
Ikea Sniglar Hack: Komplement drawer adapter
von worth-it
1
Downloads
0
Likes
0
Makes
A little Ikea Hack for the Sniglar Changing table (200.452.05).
You can add a mesh basket drawer below (590.109.88) by buying the Pax drawer in 50cm large and printing those items:
- 1x Front Right adapter
- 1x Front Left Adapter
- 4x (or 2x) Back Adapters
I just needed a few wood screws (30mm length is good for the front, 35mm for the back adapters is ideal).
Pre-drill the wood for a better finish.
Steps:
- Attach the front support to the underside of the table using screws (30mm).
- Secure the drawer rails firmly to the front support using the ikea hardware.
- With the drawer fully closed, position it in place and press it into the rails. The drawer is designed to snap in rather than slide, which prevents a child from lifting it out.
- Attach the back support to the rails using the ikea hardware.
- Secure the back support to the underside of the table (35mm screws).
You can add a mesh basket drawer below (590.109.88) by buying the Pax drawer in 50cm large and printing those items:
- 1x Front Right adapter
- 1x Front Left Adapter
- 4x (or 2x) Back Adapters
I just needed a few wood screws (30mm length is good for the front, 35mm for the back adapters is ideal).
Pre-drill the wood for a better finish.
Steps:
- Attach the front support to the underside of the table using screws (30mm).
- Secure the drawer rails firmly to the front support using the ikea hardware.
- With the drawer fully closed, position it in place and press it into the rails. The drawer is designed to snap in rather than slide, which prevents a child from lifting it out.
- Attach the back support to the rails using the ikea hardware.
- Secure the back support to the underside of the table (35mm screws).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!