IKEA Sörvallen Riser

This model slides over the existing feet of your IKEA Sörvallen sofa and extends the height by 35mm to 105mm in total. The existing feet are completely covered by the model. No screws or tools are required to install the feet. Just lift the sofa up and slide the printed feet underneath it. The 35mm extension allows a Roborock S7 to just barely pass underneath. I initially printed the feet with a height of only 30mm which was mostly sufficient, though the robot got stuck in some areas of the sofa as the clearance slightly varies due to the fabric. The slanted gap on the inside of the model is an attempt to reduce the bulge line that appears on outer wall where the internal floor is. It is still visible, but just barely noticeable from further away. One picture shows two printed models without the sofa. The model on the right was printed without this slanted gap and shows a more noticeable bulge line. (It also has a slightly thicker wall than the uploaded improved version.) I printed thi