IKEA trash can hack

When we 3D print, a lot of waste plastic is created.
From either support material prototyping or failed prints.
So it's nice to have a dedicated trash can nearby.

And it cannot get any more nearby than this.


Hardware:
----------------------
4 x M3 5.5mm machine screws

4 x M3 Brass Nuts Thread Inserts
https://bit.ly/2IOYRqo

6 x Wood screws

1 x IKEA FNISS Trash can
https://bit.ly/2sdijXy

How to mount:
------------
Hold up the trash can to where you want it and draw around it.
Draw lines from the widest part of the circle out to the edge of the table.
Hold up a rail to these lines and drill small pilot holes.
Measure the circle and find the center and draw a line there.
Mount the parts with wood screws.

See it in action:
--------------
https://www.youtube.com/watch?v=1_1sB7SRA2U

I did not create the handle, i just made room for the brass inserts.
https://www.thingiverse.com/thing:980123/#files