Thingiverse
Illuminated Angel
von bert_lz
103
Downloads
132
Likes
0
Makes
Angel, which can be illuminated by RGB LED. Lipo battery and charge controller are integrated in the base. Of course the Led can be supplied also directly with the Usb voltage of 5V. Then a resistor of 33 Ohm instead of 10 Ohm would have to be used.
The figure is printed without infill.
My slicer settings for the figure (Cura):
Layer hight: 0,1
Wall thickness: 1.2 (3 x 0.4 wall lines)
Top/Bottom Thickness: 0,8
Filling: 0%.
Combing mode: off
Supporting required - best use Cura tree support.
The white filament should be translucent. Suitable are e.g.: Geeetec or janbex.
Printing without filling is only possible without a hole at the bottom. Therefore the hole at the bottom has to be drilled after the printing.
Additional parts required:
Switch, e.g.: https://www.ebay.at/itm/332771007314
2 RGB-LED slow, e.g.: https://www.ebay.at/itm/282083177174
Lipo charging module, e.g.: https://www.ebay.at/itm/263782499558
Lipo, e.g.: https://www.ebay.at/itm/183257989282 (also 100m
The figure is printed without infill.
My slicer settings for the figure (Cura):
Layer hight: 0,1
Wall thickness: 1.2 (3 x 0.4 wall lines)
Top/Bottom Thickness: 0,8
Filling: 0%.
Combing mode: off
Supporting required - best use Cura tree support.
The white filament should be translucent. Suitable are e.g.: Geeetec or janbex.
Printing without filling is only possible without a hole at the bottom. Therefore the hole at the bottom has to be drilled after the printing.
Additional parts required:
Switch, e.g.: https://www.ebay.at/itm/332771007314
2 RGB-LED slow, e.g.: https://www.ebay.at/itm/282083177174
Lipo charging module, e.g.: https://www.ebay.at/itm/263782499558
Lipo, e.g.: https://www.ebay.at/itm/183257989282 (also 100m
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
