Illuminated Wizard Staff

This is a remix of the Full Sized Wizard Wand or Staff by skaye. (original here: https://www.thingiverse.com/thing:223622 ) I remixed it so it can be illuminated. I put a hole through the posts for wiring. I made the orbs hollow, so they can be printed with transluscent filament. (I used Colorme3D Purple Haze). After you print the orb, drill a hole up through the bottom to allow more light inside the orb. One post has a space for the battery pack. I used the guts from a free Harbor Freight flashlight. There is also a hole in the end cap for the switch, so the light can be turned on and off by tapping the staff on the ground. The lights fit in the end of the top post. Simply extend the wiring and solder the wires to the battery pack. They print on my printers with no supports. I used gyroid infill on the orb. I will upload photos when the paint and final assembly are done.