Immersion Ghost Standoff Vertical Mount

I designed this 3 piece antenna mount for my TBS Sourceone v3 7" quad, but it may work on many other designs that use 5mm standoffs. It fits an ImmersionRC Ghost antenna. The 90mm mast has a 40degree rear tilt, and the antenna top has a 10degree fore tilt. The result is the antenna is held with a 30degree rear tilt.

To make this you need to print one base, one mast, and one top. The base and top should be TPU, and mast should be PLA or PETG. Supports are needed on the mast only. To assemble, first slide the mast into the smaller hole in the base and top. It is a tight fit; sometimes rotating the mast as it goes in can help. Then slide the base over a standoff. Next slide the antenna lead through the square hole, and press the base of the antenna fully into the mount. Route the antenna lead carefully, using tape or a ziptie to keep it from the props. Reconnect to your RX and rip it!

Note: The mast holes are 3mm. You can use any stiff 3mm material you prefer instead of the printed