Tools
Zum Modell
Impact Driver Bit holder - Double bit holder
468
Downloads
240
Likes
0
Makes
This model fits on DeWalt impac drive or drils.
You can buy a single bit holder from DeWalt but they sell it 20$ and it's a single bit holder. Why not make our own. ;-)
VERSION 2:
After using it quite a lot. the plastic worn down and the bits would slip out. I upgraded the design by adding 2 tabs to fit with the bit lock groove. When installing it, I put a peace of dense foam under the tabs to help with the spring. (See picture)
You can buy a single bit holder from DeWalt but they sell it 20$ and it's a single bit holder. Why not make our own. ;-)
VERSION 2:
After using it quite a lot. the plastic worn down and the bits would slip out. I upgraded the design by adding 2 tabs to fit with the bit lock groove. When installing it, I put a peace of dense foam under the tabs to help with the spring. (See picture)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!