Slicer Discord
Impeller + Stator model V1  – Modèle 3D imprimable de MakerWorld MakerWorld
Engineering

Impeller + Stator model V1

53 Téléchargements
20 Likes
0 Makes
Voir le modèle
This is perhaps my earliest iteration to begin designing both a visually pleasing and practical propulsion system for RC aircraft or any other vehicles. Instead of using an EDF, I want to make a propulsion system where almost everything is 3d printed (besides motor, bearings and shaft), which lets me make it look a lot more like a jet engine as well as producing more power than the typical hobby EDF as it is a compressor system.Producing a combustion powered jet turbine is not possible with mainly 3d printed components, so this is simply a compressor fan system (the first half of the jet engine), but I would assume it to be possible to add combustion without an exhaust turbine. Important note: The hole for the impeller has not been bored in CAD so that you can make an adequate hole for whatever you are using to spin it.
Catégorie
Engineering
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Post-traitement
Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection