Thingiverse
Impeller Water Pump
von GermanRobotics
28
Downloads
29
Likes
0
Makes
Just a small Water pump. I wanted to use it as a cooling pump.
The Impeller fits a 3mm Shaft. The groove at the bottom of housing part 2 measures 13mm.
Test Video: https://youtu.be/BhvBUPkPt9U
Additional Hardware:
- 4x M6x45 Screws
- 4x M6 hex nuts
- a rubber lip to seal everything
The Impeller fits a 3mm Shaft. The groove at the bottom of housing part 2 measures 13mm.
Test Video: https://youtu.be/BhvBUPkPt9U
Additional Hardware:
- 4x M6x45 Screws
- 4x M6 hex nuts
- a rubber lip to seal everything
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
