ImpluseSV Figure

ImpluseSV 3D print based on Impulse's skin. The arms and head can move.

Impulse Recommended Settings:
-Use supports for the head and arms only

-Print the hair piece upsidedown and 2-3% bigger (this may need to be played around with its been almost 2 years since I made this and my tolerance skills were not good)

-Nondetailed (nonpixeled) side normal to the baseplate

-Glue eyes (and other pieces) if needed

-Sanding may be needed for the best results

-Slower speeds allow for better angles on the pixels though the effect is usually minimal

Painting:
-Use lighter filament than the color desired

-Used acrylics (but I imagine there's a better way)

-A couple of layers are needed and make sure to have a paper towel to wipe off mistakes