Impossible Passthrough Chess Board

Finally, the upload everyone has been asking for. My version of an impossible passthrough chess board. This model was inspired by GemoGens wonderful Chess Set. I simply didn't think the included board quite lived up to the pieces. So i set off designing my own impossible pass through board. This board uses 64 impossible passthrough cubes (rectangles technically) set in a frame. The frame is intentionally a bit dull so to not detract from the cubes. However, i was able to sneak in a silhouette of a pawn into the edging. Since the original Chess Set and Cube designers have limited their licensing to prevent remixes. I am not able to include their designs in this post. Since the cube is a requirement for my design, i will simply link to the cube i used here. The Cube i used was designed by The Duck Vault and can be found here. You can use this cube or any cube you wish to fill out the board. As long as you follow the below instructions. Instructions: - Cubes must be uniformly sized to X=3