Thingiverse
Impossible Star
door Thingy
31
Downloads
20
Likes
0
Makes
6-piece puzzle. Forming a star when put together.
You need to print 6 of these blocks and then try to put them together, hard the first time.
**Update:** the original design **was tight** as a *(insert sexual innuendo)* so the new one should be less swear-inducing to put together.
The simplicity scaling array adjusts exactly how tight you wish it to be, the original was the same as simplicity = [1,1,1]. I also made the actual code a bit more obvious.
**Observe:** The scaling messes up the bottom layer alignment, so you need to make sure the bottom is flat in the slicer!!!
You need to print 6 of these blocks and then try to put them together, hard the first time.
**Update:** the original design **was tight** as a *(insert sexual innuendo)* so the new one should be less swear-inducing to put together.
The simplicity scaling array adjusts exactly how tight you wish it to be, the original was the same as simplicity = [1,1,1]. I also made the actual code a bit more obvious.
**Observe:** The scaling messes up the bottom layer alignment, so you need to make sure the bottom is flat in the slicer!!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
