Improved Calibration Cube

Calibration Cube: Improved!


This is fast, and straight to the point calibration cube that can easily diagnose any printer problems. It includes overhangs, steps, thin tall poles, first layer test, 20mm walls and more. It can help you fine tune your motors steps for precise prints, overhang speed, printing temperature, has a flat top layer to check for under/overextrusion, has a flat wall to check for any Z axis issues, and also has a thin tall cylinder to ensure you're not printing too fast.

Easy, Quick Print, with Low Material Usage.

This model has been optimized to only take 4 grams of filament, and 23 minutes of printing time on my Bambulab A1.

Print Settings:

0.2mm layer height, 2 Walls, 20% Gyroid Infill, 50/mms first layer print speed, around 150-300mm/s for others on the A1, No supports.

Calibration Time!

There are many easily detectable signs of bad prints. Too many to list all of them here, but I can give a few.

Bed Leveling/First Layer Issues

If you're prints are no